Fuels and engines
Is E10 bad for your car? Compatibility and real cost
Which cars can use E10, why it uses slightly more fuel, how to work out whether it is actually cheaper, and when to avoid it.
Published 15 November 2026 · 5 minute read · By Safal Aryal, MechAxis co-founder
The short answer
For most petrol cars built this century, E10 is safe and approved by the manufacturer. The NRMA describes it as a safe and reliable fuel that is compatible with the majority of petrol cars on the road today. It is not suitable for every vehicle, and it is not always the cheapest option once you allow for slightly higher consumption. Opinion is sharply divided. The r/CarsAustralia thread 'Is there any reason I shouldn't be using Ethanol 94 (E10)?' reached more than 270 comments, and 'Why do you not pump E10?' close to 200.
What E10 is
E10 is regular unleaded petrol blended with up to 10% ethanol, an alcohol made in Australia largely from wheat starch and sorghum. Ethanol has a high octane rating, so E10 is sold as 94 RON, a little higher than regular 91. That sometimes leads people to think of it as a budget premium fuel. It is not a substitute for 95 or 98 in a car that requires them. The extra octane also does nothing for an engine designed for 91, for the same reason premium does not. Its real selling points are price and a lower share of fossil fuel in the tank.
Will it suit your car?
Check, do not assume. The NSW Government runs an E10 compatibility checker that lists petrol vehicles manufactured after 2000 where the manufacturer has provided ethanol information. The fuel flap and owner's manual are the other reliable sources. If the manual says ethanol blends up to 10% are acceptable, you are fine. Vehicles with carburettors and many older fuel-injected cars were not built with ethanol-resistant hoses and seals, and are best kept on regular unleaded. If your vehicle is not listed and you cannot find manufacturer advice, the NSW guidance is to ask the manufacturer.
It uses about 3% more fuel
Ethanol carries less energy than petrol. The NRMA puts E10 at around 3% less energy than the same volume of 91, which on average translates into about 3% higher fuel consumption. That is small, roughly the effect of driving on under-inflated tyres, and many drivers will not notice it in day-to-day use. It does mean the price on the sign is not the whole comparison. A fuel that is 1% cheaper per litre but takes you 3% less far costs more per kilometre.
Working out whether it is cheaper
The break-even is simple: E10 needs to be at least about 3% cheaper per litre than 91 to save money. As an illustration, with regular unleaded at the mid-November 2026 national average of 222.8 cents a litre reported by the NRMA, 3% is about 6.7 cents. If E10 is more than that below 91 at your station, it is the cheaper fuel per kilometre. If the gap is 2 or 3 cents, 91 is slightly ahead. Prices move daily, so do the sum at the bowser. One multiplication on your phone settles the argument.
When to avoid E10
Skip it if your manufacturer does not approve it, or if your car requires 95 or 98 and the manual does not list E10 as acceptable. Be cautious with vehicles and equipment that sit unused for long periods. Ethanol attracts moisture, and fuel left for months in a vented tank can absorb water and go stale sooner. That matters for a weekend classic, a boat, a motorbike stored over winter, and garden equipment. The NRMA notes the picture is more complicated for small engines such as mowers and whipper snippers, so follow the equipment maker's advice.
If your car runs badly after switching
A compatible car in good condition should run normally on E10. If you notice hard starting, hesitation or a fuel smell after switching, go back to regular unleaded and have the car checked. On an older vehicle the cause may be a hose or seal that was already perished. Tell the workshop which fuel you have been using and for how long. That detail saves diagnostic time, and a workshop that keeps notes against your vehicle, as those using MechAxis do, will have it on record at the next visit.
Sources
- NRMA: what is E10 fuel and why should Aussie motorists embrace it?
- NSW Government: E10 fuel and the compatibility checker
- NSW Government: E10 FAQs
- NRMA: fuel costs and supply in Australia (price update, November 2026)
- Reddit r/CarsAustralia: thread asking whether there is any reason not to use Ethanol 94 (E10)
- Reddit r/CarsAustralia: Why do you not pump E10?
- Reddit r/CarsAustralia: E10 or not?
Common questions
01Can I mix E10 with regular unleaded?+
Yes, in a compatible car. The fuels mix without any problem, and you can switch between them from tank to tank.
02Is E10 the same as 95?+
No. E10 is rated at 94 RON. A car that requires 95 or 98 should only use E10 if the manufacturer says it is acceptable.
03How do I check whether my car can use E10?+
Look inside the fuel flap and in the owner's manual, or use the NSW Government's E10 compatibility checker for vehicles made after 2000.
04Does E10 damage engines?+
Not in vehicles the manufacturer has approved for it. Older vehicles, carburetted engines and some small engines can be affected, which is why checking compatibility matters.
Run a workshop?
MechAxis keeps bookings, inspections, quotes and each vehicle's service history in one place, so your customers get clear answers like these. Try it free for 30 days.
Start free trial